Where's the monitor? plus T-moulding groove cut

The t-molding came yesterday, and cutting the groove proved easier than expected - after a couple of trial cuts on a piece of scrap, the grooves for the t-molding were knocked out in about 60 seconds, for both sides... it really helps to have the right tools :) I have also measured and drilled most of the holes for the 2x2s that I will attach the panels to, but I cannot start assembly until the monitor arrives, so that I can take actual measurements for the mounting brackets. It is really going to be a close fit! I have also finalized the control panel layout - it will basically be a Stargate layout, with an extra joystick (for Robotron and the odd 2-player game), trackball and spinner. I will have to learn how to use the spinner left-handed though - hope an old dog has room for a new trick :) The Emery Worldwide tracking page shows that the monitor is somewhere in DFW Airport, and has been for over a day now... I have no clue when to expect it - I have never dealt with Emery Worldwide before.